Xtracycle Build : 10 Step Build Process

This has been a long time coming but a few snafu’s in the second week of riding the bike caused the Xtracycle to get “hung up” until I could have someone fabricate a metal bridge for me. Without further excuses :


Step One
: Remove your rear wheel, derailleur, chain and brakes from the bike. Put these to the side as you will need them shortly.


Step Two
. Attach the carpet material to the Front Attachment Plate (FAP) and then gather these parts: French Nut (2), Spacer Washer (2) (if you have a 130mm rear end) 32mm bolts (2), FAP Bolt, FAP, washer and nut

Step Three : Thread 32mm bolts through Free Radical and into your French Nut and Spacer Washer (if needed.) Do not tighten as now you are going to sit the drops out of your bike in between Spacer Washer and French Nut.

Step Four . Align and hold with left hand your Free Radical so it is sitting FAP above chainstay bridge (if you have a chainstay.. I attached my FAP bolt through the tongue of the Free Radical, behind my chainstay bridge, through the FAP and finally into the washer bolt. Do not tighten should be only hand tight.


Step Five : Tighten FAP bolt securely. Making sure drop outs are pressed against French Bolt, tighten 32mm bolt, you may need an adjustable or cone wrench to hold the French Bolt into place.

Step Six : Reinstall Rear Wheel, I needed to purchase a larger rear rotor (203mm) as this is what the Xtracycle is set up with for more stopping power and heat displacement.

Step Seven :Reinstall Rear Derailleur and Brake with extra long cables and housing provided by Xtracycle.. I needed even more brake housing with this than Xtracycle provided as I run full length housing down my bike to my disc brake.

Step Eight : Add the chain links to your old chain, reinstall chain. Please make sure to check the life of your chain/cassette before doing this. If you they are worn it will cause the new segment of chain to slip. Click here if you need help adjusting your derailleur.

Step Nine : Check everything over, refer to Xtracycle and your owners manual for specific questions.

Step Ten : Go ride already!

___________________________________________________________________

Notes: Please grease all threads and bolts. If there is interest of specific directions on parts please let me know. This is a brief run down to show that building an Xtracycle is not as difficult or daunting if you have some bike mechanic skills!

Post navigation